by Oluwaseun | Dec 10, 2019 | Autocad Articles
Steps: Go and click on the Application menu (The big Red A or the Red Diamond symbol in 2019) Click on Option Go to open and save tab on Option dialog box and click on AutoCAD 2010 Drawing (*dwg) drop down to select AutoCAD 2007 Drawing (*dwg) Note: Any of your save...
by Oluwaseun | Dec 10, 2019 | Autocad Articles
Steps: Go and click on the Application menu (The big Red A or the Red Diamond symbol in 2019) Click on Option Go to display tab on Option dialog box and click on crosshair size input a figure or increase the slider. Then click on OK. Note: The size of the cross hair...
by Oluwaseun | Dec 10, 2019 | Autocad Articles
Steps: Type DSETTINGS and press Enter on the command line Go to SNAP AND GRID tab locate SNAP TYPE option and select the ISOMETRIC SNAP and click on OK. NOTE: That your cross hair changed to an isometric cross hair Activate by clicking on the ORTHO MODE on the...
by Oluwaseun | Dec 10, 2019 | Autocad Articles
Steps: Start your rectangle command Specify your start point, drag out and input 1200 by 225 and press ENTER Click on OFFSET or type O on the command line Then OFFSET by 75 inward
by Oluwaseun | Dec 10, 2019 | Autocad Articles
Steps: Specify the start point and end point of the line segment Continue specifying additional line segments. To undo the previous line segment, enter U at the prompt. Click Undo on the Quick Access Toolbar to cancel the entire series of line segment. Press Enter or...