by Oluwaseun | Dec 10, 2019 | Autocad Articles
Steps: Type DSETTINGS and press Enter on the command line Go to SNAP AND GRID tab locate SNAP TYPE option and select the ISOMETRIC SNAP and click on OK. NOTE: That your cross hair changed to an isometric cross hair Activate by clicking on the ORTHO MODE on the...
by Oluwaseun | Dec 10, 2019 | Autocad Articles
Steps: Start your rectangle command Specify your start point, drag out and input 1200 by 225 and press ENTER Click on OFFSET or type O on the command line Then OFFSET by 75 inward
by Oluwaseun | Dec 10, 2019 | Autocad Articles
Steps: Specify the start point and end point of the line segment Continue specifying additional line segments. To undo the previous line segment, enter U at the prompt. Click Undo on the Quick Access Toolbar to cancel the entire series of line segment. Press Enter or...
by Oluwaseun | Dec 10, 2019 | Autocad Articles
Specify the start point Do one of the following to specify the length Click a point to specify the start point. Enter the length of the line, for example 100 Do one of the following to specify the angle Enter the left angle bracket (<) and the angle, for example...
by Oluwaseun | Dec 10, 2019 | Autocad Articles
Find Specify the insertion point Enter a height or click to specify the height of the text Enter the angle value or click to specify the rotation angle. Enter the text Note: While typing, the text may be displayed the angle of rotation and at a legible size...
by Oluwaseun | Dec 10, 2019 | Autocad Articles
Steps Find Select Multiline text Specify opposite corner of a bounding box to define the width of the multiline text object. If the ribbon is active the text editor contextual tab display. Specify the initial formatting Enter the text Note: While typing, the text may...